1. Before work, it is necessary to wear work clothes, tie the cuffs, no scarf, no gloves, and the braids of female workers should be tied in the hat.
2. When using the radial drill, there shall be no obstacles within the slewing range of the cross arm. No floating objects are allowed on the cross arm and workbench.
3. At the end of the work, lower the cross arm to a lower position. The headstock is close to the column and should be clamped tightly.
4. When two or more people are working in the same machine tool, one person must be responsible for safety and unified command to prevent accidents.
5. In case of any abnormality, stop the vehicle immediately and ask relevant personnel for inspection.
6. When the deep hole drilling machine tool is running, it is not allowed to leave the work post. If it wants to leave for some reason, it must stop and cut off the power supply.
7. After the work is completed, close the main gate of the deep hole drilling machine, clean the deep hole drilling machine and clean the working place.
8. Check the protection, insurance and signaling devices on the equipment. The mechanical transmission part and electrical part shall be equipped with reliable protective devices. Whether the tools and fixtures are in good condition, otherwise they are not allowed to start.
9. The platform of deep hole drilling machine should be tight, and the workpiece should be
Clamping. When drilling small parts, special tools shall be used for clamping to prevent the parts from being taken up and rotating. It is not allowed to hold or press the drilling holes with hands.
10. For automatic cutting, select the feed speed and adjust the travel limit block. Manual feed is generally carried out according to the principle of gradually increasing and reducing pressure to avoid accidents caused by excessive force.
11. When adjusting the speed, stroke, clamping tool and workpiece of the deep hole drilling machine, and when wiping the machine, stop the machine.
12. After the deep hole drilling machine is started, it is not allowed to contact the moving workpiece, cutter and transmission part. It is forbidden to transfer or take tools and other items through the rotating part of the machine tool.
13. When the long iron chips are wound on the drill bit, it is required to stop and remove them. It is forbidden to blow them with the mouth. If the drill bit is pulled by hand, it shall be removed with a brush or iron hook.
