Skving roller burnishing machine is a high-efficiency and automatic deep hole processing special machine , which brings high work efficiency and benefits to our customers, and is durable. Then the perfect product also has its weaknesses. Today, Let's find out what are the "bad tempers" about skving roller burnishing machine.
When skving roller burnishing machine works, occasionally there will be a phenomenon of poor chip removal. At this time, you can adjust the mixing concentration, increase the amount of coolant, and you can also check the liquid pressure, but you should pay attention to the closed mixing valve. After that, the fluid pressure was adjusted to 2.5-3.1 MPa. After replacing the props, investigate the cutting conditions, and make certain adjustments to the cutting parameters, and then check whether the props of the skiving roller burnishing machine are blocked. If necessary, regrind the props and check the gas pressure. The lower limit of the air pressure must be under 5 kilograms, and the pressure should be higher in the holes smaller than 10 millimeters. When skiving roller burnishing machine is processing deep holes, we can improve the processing efficiency of the skiving roller burnishing machine as long as it guarantees the smooth progress of the processing, so it must be operated in accordance with its rules and regulations, otherwise he will also issue Temper and different discharge methods for different holes. For deep holes with deep hole discharge and micro holes with micro hole discharge, this can not only improve efficiency and precision, but also reduce the difficulty of processing.