Machine spindle Daily maintenance
1 remove the tool handle on the spindle to prevent adhesion and rust. If it is not used for a long time, the z-axis may drop, causing the tool handle to collide with the worktable
2. Clean the taper hole of the main shaft and apply lubricating oil to prevent the corrosion of the main shaft and its taper hole caused by not using for a long time.
3. Clean the filter screen of the main shaft oil cooler and air conditioner. It is recommended to regularly manage the filter screen according to the service frequency of the equipment to ensure the normal heat dissipation of the equipment.
4. Clean the aluminum scraps and iron slag in the machine tool, handle the key parts such as workbench and protective cover, and apply oil for rust prevention if necessary
5. When the machine tool is stopped, please return each axis to the original point to prevent the absolute value motor from losing the original point due to battery power failure. If there is an alarm that Z71 standby voltage is too low, yellow APC warning message, the machine tool can not be powered off and can continue processing, but please replace the battery quickly. For more information about battery replacement, please contact our sales service personnel
6. In order to maintain the machine tool better, if the quality of cutting fluid or spindle coolant affects the machining of the machine tool, it needs to be replaced with a new one. The waste liquid should be exhausted before long-term shutdown, and the water tank should be cleaned at the same time to avoid sedimentation caused by long-term shutdown.
